TS [GEN ERA L]. Transmitter Frequency. Range: Receiver Frequency. Range: Mode: Antenna Impedance: With AT antenna tuner. View and Download Kenwood TSS service manual online. HF Transceivers. TSS Transceiver pdf manual download. Also for: Sp, At, S View and Download Kenwood TSS service manual online. TSS Transceiver pdf manual download. Also for: Sp, At, So

Author: Gujar Moogurisar
Country: Oman
Language: English (Spanish)
Genre: Marketing
Published (Last): 11 November 2005
Pages: 118
PDF File Size: 18.86 Mb
ePub File Size: 8.87 Mb
ISBN: 911-5-20346-565-7
Downloads: 26234
Price: Free* [*Free Regsitration Required]
Uploader: Tam

The replacement of the supply allows the radio to run at room temperature instead of self destructing because the supply is so hot! Kenwood ts 930 service manual fan motor was originally designed to drive sergice pulley system. Cold solder joint of platee VCJ wire.

I had no problems with the internal tuner, it worked great, fast and quite accurate. Might just have a dead power supply! TSS Audio oscillation English language.

What is this project all about? A good earth ground and antenna system lightning protection is kenwood ts 930 service manual strongly recommended. All mods i have is listed on this site.! Seller assumes all responsibility for this listing. Classifieds Detail

Note that page can take a while to load, if there are many modifications. This may be corrected by changing the following components: I am delighted can share also as well as to you all. We love this problem. You must log in or sign up to reply here.


Pay careful attention to the coaxial connectors when reinstalling to ensure they are in the correct locations.

A shorted power supply pass transistor can easily destroy all of the boards in the radio. Careful adherence to this servicw should prevent reoccurrance of this symptom.

Kenwood TS-930 S Service Manual

Incorrect AC line voltage setting English language. Replace top and bottom covers to complete the modification.

TS power supply overheating. Report item — opens in a new window or tab. Careful adherence to this procedure should prevent reoccurrance of this symptom.

How much current does a TS need? Ensure that no cables are pinched between the final assembly and chassis when reinstalling the final unit.


W9GBSep 2, The motor stop when SWR is at Maximum. Unplug connectors number 16 and 20 located along the right of the Signal unit.

As long as you don’t spin the dial too fast, it will track nicely from one end to the other. G Add the Flat Spring as shown in the figures below. But, that’s water under the bridge.

Kenwood TSS Service Manual |

The West Coast Swap Service happens almost every weekend on 7. Connect the oscilloscope probe to the emitter of Q One thing he is having a problem with is the ALC meter adjustment. I will post information as it is available. Kenwood Radio Manual Pdf kenwood kdc kdc kdc kenwopd audio service manual download amazing cover letter. The 28V supply is used exclusively for the final output stage.

Most 10 Related  ASTM D5630 PDF

But the Quint supply fits perfectly within the case kenwood ts 930 service manual leaves plenty of room to install an interface board to wrap the project up easily.

Subscribe for more information Sign up to hear from us.

Delivery times may vary, kenwood ts 930 service manual during peak periods. Make the following changes to SW unit J X Please enter a number less than or equal to 8. The cause may be that Signal unit Xxx capacitor C is installed backwards. We have finished the final testing on the TS Supply upgrade and plan to release the Kennwood upgrade and make it available as well.